Скорость wifi 2.4/5GHz 952Ui-5ac2nD

Mikrotik hap ac lite
Скорость с провода равна указанным в тарифе провайдером, а вот вай-фай, что на 2.4, что на 5, выдаёт на XS айфоне 5-10 MB/s при тарифных ~100
З.Ы прошивка айфона последняя, вроде не баг из 12.1
От аппарата совсем недалеко, из перекрытий между нами не несущая стена. В упор к маршрутизатору ситуация та же.
Всю ночь вожусь с настройкой, но ни к чему так и не пришёл, ибо ламер.
Помогите пожалуйста подскажите что поправить, останусь ламером, но хоть с надеждой на интернет побыстрее.

Конфиг -

Спойлер: cfg

# may/08/2019 05:38:48 by RouterOS 6.44.3
# software id = 7X1L-01B2
#
# model = RouterBOARD 952Ui-5ac2nD
# serial number =
/interface bridge
add admin-mac= auto-mac=no comment=defconf name=bridge
/interface ethernet
set [ find default-name=ether1 ] advertise=10M-half,10M-full,100M-half,100M-full,1000M-half,1000M-full
set [ find default-name=ether2 ] advertise=10M-half,10M-full,100M-half,100M-full,1000M-half,1000M-full
set [ find default-name=ether3 ] advertise=10M-half,10M-full,100M-half,100M-full,1000M-half,1000M-full
set [ find default-name=ether4 ] advertise=10M-half,10M-full,100M-half,100M-full,1000M-half,1000M-full
set [ find default-name=ether5 ] advertise=10M-half,10M-full,100M-half,100M-full,1000M-half,1000M-full
/interface pppoe-client
add add-default-route=yes disabled=no interface=ether1 name=pppoe-out1 password= use-peer-dns=yes user=
/interface wireless
set [ find default-name=wlan1 ] band=2ghz-onlyn channel-width=20/40mhz-XX country=russia3 disabled=no distance=indoors frequency=auto hw-retries=10 mode=ap-bridge name=2.4MHz_Network radio-name=2.4Ghz_14_floor ssid=2.4Ghz_auto wireless-protocol=802.11 wps-mode=disabled
set [ find default-name=wlan2 ] adaptive-noise-immunity=ap-and-client-mode band=5ghz-onlyac channel-width=20/40/80mhz-XXXX country=russia3 disabled=no disconnect-timeout=15s distance=indoors hw-protection-mode=rts-cts hw-retries=10 mode=ap-bridge name=5MHz_Network on-fail-retry-time=1s \
radio-name=5Ghz_14_Floor ssid=5Ghz_private wireless-protocol=802.11 wmm-support=enabled wps-mode=disabled
/interface wireless nstreme
set "2.4MHz_Network" enable-polling=no
set "5MHz_Network" enable-polling=no
/interface list
add comment=defconf name=WAN
add comment=defconf name=LAN
/interface wireless security-profiles
set [ find default=yes ] authentication-types=wpa-psk,wpa2-psk mode=dynamic-keys supplicant-identity=MikroTik wpa-pre-shared-key=Y3rJZ7ni8F wpa2-pre-shared-key=Y3rJZ7ni8F
add authentication-types=wpa-psk,wpa2-psk mode=dynamic-keys name=profile supplicant-identity=MikroTik wpa-pre-shared-key=typidoras wpa2-pre-shared-key=typidoras
/ip hotspot profile
set [ find default=yes ] html-directory=flash/hotspot
/ip pool
add name=dhcp ranges=192.168.88.10-192.168.88.254
/ip dhcp-server
add address-pool=dhcp disabled=no interface=bridge name=defconf
/interface bridge filter
# no interface
add action=drop chain=forward in-interface=*A
# no interface
add action=drop chain=forward out-interface=*A
# no interface
add action=drop chain=forward in-interface=*B
# no interface
add action=drop chain=forward out-interface=*B
/interface bridge port
add bridge=bridge comment=defconf interface=ether2
add bridge=bridge comment=defconf interface=ether3
add bridge=bridge comment=defconf interface=ether4
add bridge=bridge comment=defconf interface=ether5
add bridge=bridge comment=defconf interface=2.4MHz_Network
add bridge=bridge comment=defconf interface=5MHz_Network
add bridge=bridge interface=*A
add bridge=bridge interface=*B
/ip neighbor discovery-settings
set discover-interface-list=LAN
/interface list member
add comment=defconf interface=bridge list=LAN
add comment=defconf interface=ether1 list=WAN
add interface=pppoe-out1 list=WAN
/interface wireless access-list
add ap-tx-limit=8
add ap-tx-limit=8
add mac-address=38:53:9C:CE:C0:55
/ip address
add address=192.168.88.1/24 comment=defconf interface=ether2 network=192.168.88.0
/ip dhcp-client
add comment=defconf dhcp-options=hostname,clientid interface=ether1
/ip dhcp-server network
add address=192.168.88.0/24 comment=defconf gateway=192.168.88.1
/ip dns
set allow-remote-requests=yes
/ip dns static
add address=192.168.88.1 name=router.lan
/ip firewall filter
add action=accept chain=input comment="defconf: accept established,related,untracked" connection-state=established,related,untracked
add action=drop chain=input comment="defconf: drop invalid" connection-state=invalid
add action=accept chain=input comment="defconf: accept ICMP" protocol=icmp
add action=drop chain=input comment="defconf: drop all not coming from LAN" in-interface-list=!LAN
add action=accept chain=forward comment="defconf: accept in ipsec policy" ipsec-policy=in,ipsec
add action=accept chain=forward comment="defconf: accept out ipsec policy" ipsec-policy=out,ipsec
add action=fasttrack-connection chain=forward comment="defconf: fasttrack" connection-state=established,related
add action=accept chain=forward comment="defconf: accept established,related, untracked" connection-state=established,related,untracked
add action=drop chain=forward comment="defconf: drop invalid" connection-state=invalid
add action=drop chain=forward comment="defconf: drop all from WAN not DSTNATed" connection-nat-state=!dstnat connection-state=new in-interface-list=WAN
/ip firewall nat
add action=masquerade chain=srcnat comment="defconf: masquerade" ipsec-policy=out,none out-interface-list=WAN
/ip ssh
set allow-none-crypto=yes forwarding-enabled=remote
/system clock
set time-zone-name=Europe/Samara
/tool mac-server
set allowed-interface-list=LAN
/tool mac-server mac-winbox
set allowed-interface-list=LAN
/tool sniffer
set filter-interface=all
/tool traffic-monitor
add disabled=yes interface=5MHz_Network name=tmon1 threshold=0

 

Так точно, прыгает с разбросом от 5-25% до 70-90%.
Но 5GHz сетей насколько можно судить по функции скана вокруг больше нет, на "Freq. Usage" скане тоже пусто.

На 2.4 сетях примерно та же ситуация, но 70-90% средний показатель.

 

При CCQ 70-90% и входящих в роутер 100 МВ (по факту 95-97), 20-25MB на ноутбуке нормально? Речь идет о 2.4. Предыдущий роутер (ASUS N66U) выдавал на ноут порядка 30MB при входящих 50.

Спойлер: config

# feb/01/2020 14:09:09 by RouterOS 6.44.6
# software id = BV1B-WWBQ
#
# model = RB952Ui-5ac2nD
# serial number = B87F0AA5FDE2
/interface bridge
add admin-mac=74:4D:28:9A:35:73 auto-mac=no comment=defconf name=bridge
/interface wireless
set [ find default-name=wlan1 ] band=2ghz-b/g/n channel-width=20/40mhz-Ce \
country=russia disabled=no frequency-mode=regulatory-domain mode=\
ap-bridge ssid=skynet tx-power=15 tx-power-mode=all-rates-fixed \
wireless-protocol=802.11
set [ find default-name=wlan2 ] band=5ghz-a/n/ac channel-width=\
20/40/80mhz-Ceee country=russia disabled=no frequency=auto \
frequency-mode=regulatory-domain mode=ap-bridge ssid=skynet5Mhz \
wireless-protocol=802.11
/interface wireless nstreme
set wlan1 enable-polling=no
set wlan2 enable-polling=no
/interface list
add comment=defconf name=WAN
add comment=defconf name=LAN
/interface wireless security-profiles
set [ find default=yes ] authentication-types=wpa-psk,wpa2-psk mode=\
dynamic-keys supplicant-identity=MikroTik wpa-pre-shared-key=******** \
wpa2-pre-shared-key=*******
/ip hotspot profile
set [ find default=yes ] html-directory=flash/hotspot
/ip pool
add name=dhcp ranges=192.168.88.10-192.168.88.254
/ip dhcp-server
add address-pool=dhcp disabled=no interface=bridge name=defconf
/interface bridge port
add bridge=bridge comment=defconf interface=ether2
add bridge=bridge comment=defconf interface=ether3
add bridge=bridge comment=defconf interface=ether4
add bridge=bridge comment=defconf interface=ether5
add bridge=bridge comment=defconf interface=wlan1
add bridge=bridge comment=defconf interface=wlan2
/ip neighbor discovery-settings
set discover-interface-list=LAN
/interface list member
add comment=defconf interface=bridge list=LAN
add comment=defconf interface=ether1 list=WAN
/ip address
add address=192.168.88.1/24 comment=defconf interface=ether2 network=\
192.168.88.0
/ip dhcp-client
add comment=defconf dhcp-options=hostname,clientid disabled=no interface=\
ether1
/ip dhcp-server network
add address=192.168.88.0/24 comment=defconf gateway=192.168.88.1
/ip dns
set allow-remote-requests=yes servers=198.153.192.50
/ip dns static
add address=192.168.88.1 name=router.lan
/ip firewall filter
add action=accept chain=input comment=\
"defconf: accept established,related,untracked" connection-state=\
established,related,untracked
add action=drop chain=input comment="defconf: drop invalid" connection-state=\
invalid
add action=accept chain=input comment="defconf: accept ICMP" protocol=icmp
add action=drop chain=input comment="defconf: drop all not coming from LAN" \
in-interface-list=!LAN
add action=accept chain=forward comment="defconf: accept in ipsec policy" \
ipsec-policy=in,ipsec
add action=accept chain=forward comment="defconf: accept out ipsec policy" \
ipsec-policy=out,ipsec
add action=fasttrack-connection chain=forward comment="defconf: fasttrack" \
connection-state=established,related
add action=accept chain=forward comment=\
"defconf: accept established,related, untracked" connection-state=\
established,related,untracked
add action=drop chain=forward comment="defconf: drop invalid" \
connection-state=invalid
add action=drop chain=forward comment=\
"defconf: drop all from WAN not DSTNATed" connection-nat-state=!dstnat \
connection-state=new in-interface-list=WAN
/ip firewall nat
add action=masquerade chain=srcnat comment="defconf: masquerade" \
ipsec-policy=out,none out-interface-list=WAN
/ip ssh
set forwarding-enabled=remote
/system clock
set time-zone-name=Asia/Krasnoyarsk
/tool mac-server
set allowed-interface-list=LAN
/tool mac-server mac-winbox
set allowed-interface-list=LAN