Здравствуйте! Помогите разобраться в ситуации: железки - RB2011UiAS-2HnD-IN и RBCAPGI-5ACD2ND Левой пяткой через правое ухо настроил Ростелеком, IPTV и CAPSMAN на 2.4 и 5 Ghz. Но, на 5 Ghz скорость больше 80 мегабит, а на 2.4 нету и 10, а аплоад вообще 2 мегабит не выдает. Конфиг прилагаю. Подскажите, пожалуйста, куда копать. # feb/27/2019 10:36:06 by RouterOS 6.43.11 # software id = JNJ3-5FL0 # # model = 2011UiAS-2HnD # serial number = 91E1094298A2 /caps-man channel add band=2ghz-g/n control-channel-width=20mhz extension-channel=Ce frequency=\ 2412 name=channel1 tx-power=20 add band=5ghz-a/n/ac frequency=5180 name=channel2 tx-power=20 /interface bridge add admin-mac=B8:69:F4:A1EC auto-mac=no mtu=1500 name=Bridge-Local add name=bridge-IPTV /interface ethernet set [ find default-name=ether10 ] advertise=\ 10M-half,10M-full,100M-half,100M-full,1000M-half,1000M-full name=5acD2nD set [ find default-name=ether2 ] name=LAN2-Master speed=100Mbps set [ find default-name=ether3 ] name=LAN3-Slave speed=100Mbps set [ find default-name=ether4 ] name=LAN4-Slave speed=100Mbps set [ find default-name=ether5 ] name=LAN5-Slave speed=100Mbps set [ find default-name=ether6 ] advertise=\ 10M-half,10M-full,100M-half,100M-full,1000M-half,1000M-full name=WAN1 set [ find default-name=ether1 ] speed=100Mbps set [ find default-name=ether7 ] advertise=\ 10M-half,10M-full,100M-half,100M-full,1000M-half,1000M-full set [ find default-name=ether8 ] advertise=\ 10M-half,10M-full,100M-half,100M-full,1000M-half,1000M-full set [ find default-name=ether9 ] advertise=\ 10M-half,10M-full,100M-half,100M-full,1000M-half,1000M-full /interface pppoe-client add add-default-route=yes disabled=no interface=WAN1 keepalive-timeout=60 \ max-mru=1492 max-mtu=1400 mrru=1500 name=pppoe-out1 password=******* \ use-peer-dns=yes user=880527_R@msk /interface wireless # managed by CAPsMAN # channel: 2412/20-Ce/gn(20dBm), SSID: MikroTikCAP, local forwarding set [ find default-name=wlan1 ] adaptive-noise-immunity=ap-and-client-mode \ country=russia disabled=no distance=indoors frequency-mode=\ regulatory-domain mode=ap-bridge ssid=MikroTik wmm-support=enabled /caps-man datapath add bridge=Bridge-Local client-to-client-forwarding=yes local-forwarding=yes \ name=datapath1 /caps-man security add authentication-types=wpa2-psk encryption=aes-ccm,tkip group-encryption=\ aes-ccm name=security1 passphrase=proper2004 /caps-man configuration add channel=channel1 country=russia datapath=datapath1 datapath.bridge=\ Bridge-Local datapath.client-to-client-forwarding=yes \ datapath.local-forwarding=yes distance=indoors mode=ap name=cfg1 \ rx-chains=0,1,2 security=security1 ssid=MikroTikCAP tx-chains=0,1,2 add channel=channel2 country=russia datapath=datapath1 datapath.bridge=\ Bridge-Local distance=indoors mode=ap name=cfg2 security=security1 ssid=\ MikroTikCAP5G /caps-man interface add configuration=cfg2 configuration.country=russia configuration.distance=\ indoors configuration.mode=ap configuration.rx-chains=0,1,2 \ configuration.ssid=MikroTikCAP5G configuration.tx-chains=0,1,2 disabled=\ no l2mtu=1600 mac-address=B8:69:F45:BB:E0 master-interface=none name=\ cap2 radio-mac=B8:69:F45:BB:E0 radio-name=B869F4D5BBE0 /interface wireless security-profiles set [ find default=yes ] authentication-types=wpa2-psk eap-methods="" mode=\ dynamic-keys supplicant-identity=MikroTik wpa2-pre-shared-key=proper2004 /ip pool add name=dhcp_pool1 ranges=192.168.88.2-192.168.88.254 add name=default-dhcp-5 ranges=172.17.113.10-172.17.113.254 /ip dhcp-server add address-pool=dhcp_pool1 disabled=no interface=Bridge-Local name=dhcp1 add address-pool=default-dhcp-5 disabled=no interface=bridge-IPTV name=\ defconf-5 /tool user-manager customer set admin access=\ own-routers,own-users,own-profiles,own-limits,config-payment-gw /caps-man manager set enabled=yes /caps-man provisioning add action=create-dynamic-enabled hw-supported-modes=gn master-configuration=\ cfg1 add action=create-dynamic-enabled hw-supported-modes=an master-configuration=\ cfg2 /interface bridge port add bridge=Bridge-Local interface=LAN2-Master add bridge=Bridge-Local interface=wlan1 add bridge=Bridge-Local hw=no interface=5acD2nD add bridge=Bridge-Local interface=LAN3-Slave add bridge=Bridge-Local interface=LAN4-Slave add bridge=Bridge-Local interface=LAN5-Slave add bridge=cap5 interface=*19 add bridge=bridge-IPTV interface=ether9 /interface wireless cap # set discovery-interfaces=Bridge-Local enabled=yes interfaces=wlan1 /ip address add address=192.168.88.1/24 interface=Bridge-Local network=192.168.88.0 add address=1.1.1.1/24 interface=WAN1 network=1.1.1.0 add address=172.17.113.1/24 interface=bridge-IPTV network=172.17.113.0 /ip dhcp-server lease add address=192.168.88.247 client-id=1:e4:11:5b:93:fc:bc mac-address=\ E4:11:5B:93:FC:BC server=dhcp1 add address=192.168.88.237 allow-dual-stack-queue=no always-broadcast=yes \ mac-address=E0:06:E6:8C:C1B server=dhcp1 /ip dhcp-server network add address=172.17.113.0/24 dns-server=213.140.228.30,213.140.228.190 \ gateway=172.17.113.1 netmask=24 add address=192.168.88.0/24 gateway=192.168.88.1 /ip dns set allow-remote-requests=yes servers=213.140.228.30,213.140.228.190 /ip firewall filter add action=accept chain=input comment=UnblockCapsman dst-address-type=local \ src-address-type=local add action=accept chain=input in-interface=WAN1 protocol=igmp add action=accept chain=input dst-port=5000 in-interface=WAN1 protocol=udp \ src-port="" add action=drop chain=input in-interface=pppoe-out1 /ip firewall nat add action=masquerade chain=srcnat out-interface=pppoe-out1 /lcd set backlight-timeout=never default-screen=stat-slideshow /lcd interface pages set 0 interfaces="sfp1,ether1,LAN2-Master,LAN3-Slave,LAN4-Slave,LAN5-Slave,WAN\ 1,ether7,ether8,ether9,5acD2nD" /routing igmp-proxy set quick-leave=yes /routing igmp-proxy interface add alternative-subnets=0.0.0.0/0 interface=WAN1 upstream=yes add interface=bridge-IPTV /system clock set time-zone-name=Europe/Moscow /system identity set name="\D0\EE\F3\F2\E5\F0" /system lcd set contrast=0 enabled=no port=parallel type=24x4 /system lcd page set time disabled=yes display-time=5s set resources disabled=yes display-time=5s set uptime disabled=yes display-time=5s set packets disabled=yes display-time=5s set bits disabled=no display-time=5s set version disabled=yes display-time=5s set identity disabled=yes display-time=5s set pppoe-out1 disabled=yes display-time=5s set Bridge-Local disabled=yes display-time=5s set bridge-IPTV disabled=yes display-time=5s set cap2 disabled=yes display-time=5s set wlan1 disabled=yes display-time=5s set sfp1 disabled=yes display-time=5s set ether1 disabled=yes display-time=5s set LAN2-Master disabled=yes display-time=5s set LAN3-Slave disabled=yes display-time=5s set LAN4-Slave disabled=yes display-time=5s set LAN5-Slave disabled=yes display-time=5s set WAN1 disabled=yes display-time=5s set ether7 disabled=yes display-time=5s set ether8 disabled=yes display-time=5s set ether9 disabled=yes display-time=5s set cap1 disabled=yes display-time=5s set "5acD2nD" disabled=yes display-time=5s set cap5 disabled=yes display-time=5s /tool user-manager database set db-path=user-manager UPD. Заметил, что если уйти от CAP и получать WiFi от роутера то скорость на 2.4 составляет 30 мегабит, получается режется только раздача 2.4 от точки доступа...
